Home


Electronic Stability Program (ESP)

New MK25/25E anti-lock brake system



Continental Tevesí next-generation antilock braking system, the MK25e, is making its worldwide debut on the 2005 Jeep Grand Cherokee. The MK25e is designed to prevent the wheels from locking during braking, providing increased stability and the capability to continue to steer the vehicle during hard braking. The MK25e also includes traction control (ESP), which detects wheel spin and applies the brake at the spinning wheel, effectively transferring torque to those wheels that have traction.

Electronic Stability Program (ESP) is a stability enhancement system designed to electronically detect and assist drivers in critical driving situations and under adverse conditions...automatically. Using signals from sensors throughout the vehicle, the system determines the appropriate brake and throttle adjustments for directional stability of the vehicle.

Electronic sensors are strategically placed in the vehicle, allowing ESP to analyze steering wheel activity, wheel speeds, acceleration and the vehicles' rotation about its vertical axis (technically named yaw). During motion, the collected data is continually compared to determine whether the actual course of the vehicle corresponds to the direction the driver is steering the vehicle. If not, ESP springs into action, correcting the vehicle's direction to coincide with where the driver is pointing it through a series of brake and engine interventions. The effect is to help correct oversteer and understeer and to coincide with where the driver is pointing the vehicle to help keep it on the road.

Continental Automotive Systems also will supply the 2005 Jeep Grand Cherokee with brake boosters and master cylinders, wheel speed sensors, and the seat heating modules.


During Understeer:

In an understeer situation, the front end of the car tends to slide out. ESP automatically applies the inside, rear brake to help you acheive your desired turn. It may also reduce the engine's power.

During Oversteer:

In an oversteer situation, the rear end of the car tends to slide out or "fishtail". ESP automatically applies the outside, front brake to help you correct "fishtailing".

Advantages of ESP:

  • ESP constantly compares the driver's intended course with the vehicle's actual course and compensates for any differences.
  • ESP responds to help you drive safely whenever it senses impending wheel lock-up, wheel spin or loss of vehicle control.
  • It helps improve traction, maneuverability and stability in all weather conditions.

ESP Assists During All Driving Situations:

  • Braking
  • Accelerating
  • Cornering


Electronic Stability Program



Electronic Stability Program



Uconnect

ESP functions and components



ESP operation in the WK


ESP (Electronic Stability Program) enhances directional control and reduces driving wheel spin of the vehicle under various driving conditions. ESP corrects for over/understeering of the vehicle by applying brakes to the appropriate wheel. Engine torque is also limited. The "ESP Indicator Light," located in the instrument cluster, starts to flash as soon as the tires lose traction and the ESP system becomes active.

Chrysler introduced an additional enhancement on the all-new Jeep Grand Cherokee, an electronic rollover mitigation system that extends the ESP technology and provides enhanced vehicle stability during emergency maneuvers on all surfaces. The system observes and monitors the vehicle roll attitude and lateral force to estimate the potential for a rollover situation. If necessary, the engine torque is reduced and a short burst of full braking is applied to the appropriate wheel to help stabilize the vehicle attitude and reduce the vehicle's lateral force.

These systems build on the Chrysler Group electronic chassis controls which include Anti-Lock Brake System (ABS) and All-Speed Traction Control (TCS). The Anti-Lock Brake System keeps the vehicle straight while retaining steering capability when braking on slippery surfaces by preventing wheel lock-up. It benefits from state-of the-art electronics that provide a more refined system response than in the past. All-Speed TCS enhances mobility and prevents wheel slip when accelerating on slippery surfaces. It also provides a measure of directional stability control -- an advancement beyond prior traction control systems. Using the wheel-speed sensors, it can detect excessive yaw and help keep the car on the intended course as, for instance, when accelerating around a curve.

In addition to the brake engagement at low speeds used by conventional traction control systems, All-Speed TCS uses throttle control as well. This makes the vehicle less reliant on brake application alone to maintain traction, increases the operating speed range, and more closely modulates speed and acceleration, to provide smoother operation. With All-Speed TCS reducing engine torque when accelerating, it is possible to achieve almost seamless torque application at the wheels. All-Speed TCS also benefits from state-of-the art electronics that provide a much more refined system response than in the past.


Operation:

To turn the ESP system OFF, press the switch, located below the climate controls in the center stack, until the "ESP Indicator Light" in the instrument cluster turns on and the message "ESP SYSTEM DISABLED" appears in the Electronic Vehicle Information Center (EVIC). To turn the system back ON, press the switch a second time until the "ESP Indicator Light" turns off. ESP is always available during braking (in 4WD Hi) even if it has been switched off.

When the ESP system has been switched off, a feature of the system remains active. This feature functions similar to a limited slip differential and controls the wheel spin across an axle. If one wheel on an axle is spinning faster than the other, the system will apply the brake of the spinning wheel and allow more engine torque to be applied to the wheel that is not spinning.

To improve the vehicle's traction when driving with snow chains, or starting off in deep snow, sand or gravel, it may be desirable to switch off the ESP by pressing the ESP switch.

With the ESP switched off, the engine torque reduction and stability features are cancelled. Therefore, the enhanced vehicle stability offered by ESP is unavailable.

If the "ESP Indicator Light" begins to flash during acceleration, ease up on the accelerator and apply as little throttle as possible. Be sure to adapt your speed and driving to the prevailing road conditions. When the "ESP Indicator Light" is illuminated continuously, the ESP is switched off. To return to the enhanced vehicle stability offered by ESP, press the ESP switch (the "ESP Indicator Light" in the instrument cluster goes out). Avoid spinning one drive wheel. This may cause serious damage to the drive train.

NOTE:

  • The "ESP Indicator Light" comes on momentarily each time the ignition switch is turned ON.
  • Each time the ignition is turned ON, the ESP System will be ON even if it was turned off previously.
  • The ESP Control System will make buzzing or clicking sounds when it is active.



There are two Electronic Vehicle Information Center (EVIC) messages associated with the Electronic Stability Control System:

1. ESP System Disabled

This message will be displayed if the ESP System has been turned off using the switch, or if there is a temporary condition that will result in partial or no ESP function. The "ESP Indicator Light" will be on when the system is disabled or only partial function is allowed. The "ESP SYSTEM DISABLED" message and the "ESP Indicator Light" being illuminated without the switch being depressed is not an indication that service of the electronic brake system is required.

Also, the "ESP SYSTEM DISABLED" message will be present when the vehicle is shifted into 4WD LOW.

2. Service Elec Brake System

This message will be displayed if a condition exists that may require servicing the electronic brake system. When this message is displayed and the "ESP Indicator Light" is on, there is a malfunction of the ESP System. If the "SERVICE ELEC BRAKE SYSTEM" message continues to be displayed after several ignition cycles and the vehicle has been driven several miles at speeds greater than 30 mph (48 km/h), see your authorized dealer for service.


WARNING!
ESP (Electronic Stability Program) cannot prevent the natural laws of physics from acting on the vehicle, nor can it increase the traction afforded. The ESP cannot prevent accidents, including those resulting from excessive speed in turns, or hydroplaning. Only a safe, attentive, and skillful driver can prevent accidents. The capabilities of an ESP equipped vehicle must never be exploited in a reckless or dangerous manner which could jeopardize the user's safety or the safety of others.





Home